Replacing broken clips on your Ford? Our Ford F3LY-14570-B replacement push rivets are an aftermarket replacement for Ford OEM part F3LY-14570-B (cross-referenced with 11561878): the 8mm nylon push retainer used on Ford rocker panels, wheel liners and air inlet ducts.
Where the Ford uses 8mm push rivets
- Rocker panel moldings
- Wheel liner and splash shield retainers
- Air inlet duct fasteners
Important: Ford used many clip styles across its lineup, so measure first. We don't list Ford models for this part; match the hole and the old clip instead.
Check the fit before you order
- Pop out one old clip and measure the hole. A 5/16" drill bit that just slips through confirms 8mm. If the hole is 9mm or 10mm, these are not your clip.
- Check the panel stack: these fit 8mm holes with roughly 2–6mm of panel stack-up.
- To remove an old rivet, work a trim-clip tool or forked pry tool under the head and lift it straight out.
- Line up the panel and frame holes and push the new rivet in until the head sits flat; the legs expand behind the panel. Use a new rivet each time: removal deforms the legs.
More help: push rivet size guide · how many do I need? · how to remove push rivets
Specs
- 8mm shank, fits 8mm (5/16") holes
- 15mm head
- Black UV-resistant nylon
- Sold individually or in 50, 100, 250, 500 and 1,000 packs
- Ships from South Carolina in 1–2 business days (USPS with tracking)
Shop Ford F3LY-14570-B push rivets: singles to 1,000-packs →
Other makes: Chevrolet · GMC · Nissan · car & truck clips
FAQ
Which Ford part do these replace?
Ford OEM F3LY-14570-B (cross-referenced with 11561878), the 8mm nylon push retainer used on Ford rocker panels, wheel liners and air inlet ducts. See the Ford F3LY-14570-B listing.
Do they fit every Ford clip?
No. Ford used many clip styles across its lineup. These fit 8mm (5/16") holes with about 2–6mm of panel stack. Pop out one old clip and gauge the hole with a 5/16" drill bit before ordering.
Can I reuse the old clips?
No. Removal deforms the legs, so fit a new rivet each time.