Printable Push Rivet Hole Gauge & Size Chart

Free printable push rivet hole gauge. Not sure whether your clip hole is 8mm? Print this one-page gauge, lay it over the empty hole and you will know in seconds. It has actual-size circles for 6, 7, 8, 9 and 10mm holes, a 5/16" drill-bit check, a 15mm head template and a grip-range ruler for the panel stack.

Download the hole gauge (PDF, 1 page, US Letter) →

How to print it at the right size

  1. Open the PDF and choose Print.
  2. Set scale to 100% or Actual size. Turn off "Fit to page" or "Shrink to fit".
  3. Measure the 50mm bar at the top with a ruler. If it is not exactly 50mm, your printer scaled the page: reprint before measuring anything.

How to use the gauge

  1. Pop out one old clip. Measure the hole, not the old rivet: removal and age deform the legs.
  2. Lay the sheet over the hole. The circle whose edge matches the hole edge is your size. 8mm = 5/16" (7.94mm).
  3. Check the head: the 15mm circle must cover the hole with a margin of panel all round.
  4. Check the panel stack: press the layers together and compare with the ruler. Our 8mm rivet grips about 2–6mm.

On screen preview (only accurate when printed at 100%):

6 mm7 mm8 mm9 mm10 mm

Which push rivet size do you need?

Hole Inch Our rivet?
6mm ~1/4" No: too small for an 8mm rivet
7mm ~9/32" No: common on some car clips
8mm 5/16" Yes: shop 8mm push rivets
9–10mm ~3/8" No: an 8mm rivet will pull out

We stock 8mm push rivets only (15mm head, 21mm long, black nylon). The full measuring guide is on the push rivet size chart page, and the quantity calculator tells you how many to buy.

Popular 8mm push rivets

Share it

Forum moderators, clubs and repair shops are welcome to link to this page or the PDF. Please link rather than re-host, so readers always get the current version.

FAQ

Is 5/16" the same as 8mm?

Close enough for push rivets: 5/16" is 7.94mm, so 8mm push rivets fit 5/16" holes.

My printout's circles look wrong. Why?

The printer scaled the page. Reprint at 100% / Actual size and check the 50mm bar.

Can I check without printing?

Yes: a 5/16" drill bit that just slips through the hole means 8mm. If a 3/8" bit also goes in, the hole is too big.